![]() your custom action is marked as 64bit if applicable. your package is marked as 64bit from the Install Parameters page Launch file or open URL Using a 64-bit Launcher. Uninstalled the software since i tried to install it before, partial intallation was still trying to run the program. In the case of a 64-bit CMD or BAT file you can use another predefined custom action called I had the same problem after trying to re-install a software for my Sprint Card after doing a system restoration. ![]() Contact your support personnel or package vendor. A program run as part of the setup did not finish as expected. Launch file or open URLpredefined custom action. There is a problem with this Windows Installer package. ![]() ![]() However, in Advanced Installer you can run a CMD or BAT file through a Windows Installer cannot launch batch files directly by using installed or attached custom actions. How did you add the batch file Custom Action for the Setup project? I doubt it has anything related to Operation System, would you please try the steps in this link?
0 Comments
Leave a Reply. |